Self-aligning ball bearing 1300 series have a tapered cylindrical hole and two profiles, the cage material is steel, synthetic resin. Characterized by the sphere of the outer ring groove, with the Auto Center feature, it is possible to compensate for the shaft deviation and axial deviation caused by the degree of error, but the relative inclination of the inner ring and outer ring is no more than 3 degrees .
Alignment error on regulatory agency capabilities. Also closed and no longer required lubrication design, proper condition without maintenance. Installed in adapter sleeve and in self-aligning bearing of SKF Pillow Block Bearing supplied to customers of economical configuration. 2.1 Bearing alignment cylindrical hole (10000K type) 2.2 Bearing alignment taper hole (10000K type) 2.3 with ball bearing alignment adapter sleeve (10000K + H0000 type).
Self-adjusting bearing structure: dust cover and deep groove seal of the bearing assembly have been filled when the appropriate amount of grease should not be heated before installation without washing, during use No need to reprocess. - lubrication, to adapt to running temperatures in the range -30 ℃ to +120 ℃.
Because with two bowls and arcs in the outer ring groove, the alignment ball bearing is self-aligning, and can withstand the shaft and bearing angle error between prone to bending and misalignment working conditions. He has a cylindrical hole with a drill hole and two structures, steel cage material, synthetic resin. Self-adjusting bearing The rolling friction is the lowest of all, so even at high speeds it only has a smaller temperature rise.
* Industrial applications:
Suitable for precision tools, low noise motors, automobiles, motorcycles and general machinery, machinery industry, the most widely used types of bearings.
Double self-adjusting ball bearing has a spherical groove on the outer ring and a dual raceway on the inner ring. This feature gives the bearings their self-aligning feature, allowing the shaft to be angled from the housing. They are therefore particularly suitable for applications where shaft deviation can arise due to mounting errors or shaft misalignment.